Technical data

CU230P-2 Control Units, Getting Started
24 A5E02484096, 05/2009
Note
Restoring to the factory setting during commissioning
As a first step in the basic commissioning, the Wizard offers "Restore factory setting". This option is always practical if, under
certain circumstances, your Control Unit was used in other applications and you are not completely certain which settings
were made at the CU.
Changing numerical values from the IOP
Numerical values are changed digit-by-digit in the IOP. The presently selected digit is changed by turning the navigation
wheel and is accepted by pressing OK; the next digit (to the right) is selected at the same time. Every numerical value must
be accepted digit by digit by pressing OK, even if a value is not changed.
The display jumps to the next numerical value if the last digit of a number is accepted with OK.
The ESC key can be used to jump back to the previous value if an incorrect value is entered.
Once basic commissioning has been completed, a summary of the settings is provided under the title "Summary of settings".
Using the navigation wheel, scroll in this screen until "Continue". If you acknowledge this with OK, you change into a screen
that allows you to select either "Save" or "Cancel Wizard". If you press Save, your settings are saved in a non-volatile
fashion and the "Settings saved successfully" message is displayed. Acknowledge this message with OK. Then, when
switching-on for the first time, depending on the entries you made, the motor data identification is performed or the motor
rotates corresponding to the values that have been set.
After the basic commissioning, you can additionally set a voltage boost for starting and a PID controller using the following
Wizards.
● Boost
Voltage boost
● PID Wizard
PID controller