User Manual

ManualsBrandsSiemens ManualsVariable Speed DriveSINAMICS G120 CU240B/E-2 Control Units List Manual

List of parameters

Parameters

1-35

SINAMICS G120 CU240B/E-2 Control Units List Manual (LH11), 01/2013

250: Identification stator inductance LQLD

270: Identification stator resistance

290: Identification valve lockout time

300: Stationary measurement selected

Note: Re r0047 = 300:

This value is also displayed if encoder calibration p1990 is selected.

Description: Displays the effective Command Data Set (CDS).

Dependency: Refer to: p0810, p0811, r0836

Note: The Command Data Set selected using a binector input (e.g. p0810) is displayed using r0836.

Description: Displays the effective Drive Data Set (DDS).

Dependency: Refer to: p0820, p0821, r0837

Note: When selecting the motor data identification routine and the rotating measurement, the drive data set changeover is

suppressed.

Description: Display and connector output for status word 1.

r0050.0...1 CO/BO: Command Data Set CDS effective / CDS effective

Access level: 3 Calculated: - Data type: Unsigned8

Can be changed: - Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: 8560

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 CDS eff. bit 0 ON OFF -

01 CDS eff. bit 1 ON OFF -

r0051.0...1 CO/BO: Drive Data Set DDS effective / DDS effective

Access level: 2 Calculated: - Data type: Unsigned8

Can be changed: - Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: -

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 DDS eff. bit 0 ON OFF -

01 DDS eff. bit 1 ON OFF -

r0052.0...15 CO/BO: Status word 1 / ZSW 1

Access level: 2 Calculated: - Data type: Unsigned16

Can be changed: - Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: -

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 Rdy for switch on Yes No -

01 Ready Yes No -

02 Operation enabled Yes No -

03 Fault present Yes No -

04 Coast down active (OFF2) No Yes -

05 Quick Stop active (OFF3) No Yes -

06 Switching on inhibited active Yes No -

07 Alarm present Yes No -

08 Deviation setpoint/actual speed No Yes -

09 Control request Yes No -

10 Maximum speed reached Yes No -

11 I, M, P limit reached No Yes -

12 Motor holding brake open Yes No -