User Manual

Parameters

Quick commissioning (p0010 = 1)

1-518

SINAMICS G120 CU240B/E-2 Control Units List Manual (LH11), 01/2013

If p0010 = 1 is selected, p0003 (user access level) can be used to select the parameters that

are to be accessed.

At the end of the quick commissioning, set p3900 = 1 to perform the required motor calcula-

tions and reset all other parameters (not included in p0010 = 1) to their default settings.

p1300 Open-loop/closed-loop control operating mode 2 C(1)T

p1500 Torque setpoint selection 2 C(1)T

p1900 Motor data identification and rotating measurement 2 C(1)T

p1905 Parameter tuning selection 1 C(1)T

p2196 Torque utilization scaling 1 C(1,3)UT

p3900 Completion of quick commissioning 1 C(1)

Note:

This only applies for the quick commissioning.

Table 1-7 Quick commissioning (p0010 = 1), continued

Par. no. Name Access level Change-

able