User Manual

Migration procedures

Building Technologies

016_DMS_DMS8000_Migration_from_DMS7000_MP4.15_A6V10062443_a_en.doc

Fire Safety & Security Products

06.2008

Fig. 36 Composer: Set the attributes for HTML step.

Associate procedures to points

Typically, the operating procedures are automatically applied to MM8000 points

according to the typical event mapping. However, you can disable the automatic

mechanism for some or all procedures:

Enable Auto assignment: Un-check this box (see Fig. 34, D).

In order to associate operating procedures to individual points, customise the

Event and OP extensor tab with the following steps (see Fig. 37):

(A) Default settings: Un-check this box.

If it is checked, then the point will get the default events and operating pro-

cedure assignments for all its properties.

Note: Whatever you modified after un-checking the box, you can always go

back to the default setting by simply checking this option again.

(C6) Enable Auto-assignment: Uncheck the box.

If it is checked, the point will get the default operating procedure assign-

ments for all its properties. If the auto-assignment is not checked, you can

manually assign a procedure for each point property.

Note: Whatever you modified after un-checking the box, you can always go

back to the default setting by simply checking this option again.

(C6) Operating procedure: Here you can select one of the procedures avail-

able and assign it to the selected property for the event it generates: