User Manual

121
Building Technologies
MM8000 Installation, Function & Configuration, Commissioning, Safety Regulations
Fire Safety & Security Products 06.2009
The commands are specified indicating:
– Field point: In the list that appears, click one of the
points linked to the Sequence; the points are listed with
their Customer Text, Technical Text, or both (see
2 at
p.
108).
– Property: Open the drop-down list and select one of
the properties of the point, typically “Active” or “Off”.
The list of properties depends on the specific point.
– Command: Define the actual action, which one of the
following:
– Quiet: Set to normal state.
– Active: Set to active state.
– Acknowledge: Send out an acknowledge command.
– Reset: Send out a reset command.
In case of doubts, check the exact behaviour of the in-
volved property in a real application.
Note: More than one point can be selected in order to send
out multiple commands in a single instruction. Use the Shift
or Ctrl key to select more items and then select a (com-
mon) command for all of them.
The delays are programmable in hours, minutes, seconds,
and tenths of sec.
Note: max. delay can be: 23h, 59’,59.9”.
In the Switch Camera to Monitor command, camera and
monitor are selected in drop-down lists that include the
devices linked to the reaction node (step 1 above).
3.D Check the resulting Sequence program as shown on the
screen (see the example in the following
Fig.127). If you
wish to modify any of the steps, right click it and then select
the required action in the menu list (Modify, Copy/Paste,
Delete, and Print).
Note: In order to delete complex instructions (e.g. an
IF/THEN clause), you have to select the entire structure.
Applying Windows standards, use the Shift or Ctrl key
when click the instructions.