User Manual

Configuring control units – Intrusion
187
Building Technologies
DMS8000 Network, Fire, and Intrusion Connectivity Configuration Guide
Fire Safety & Security Products 06.2009
5.5.1 Configuration checklist
Verify that you have satisfied the items needed in the first checklist before proceed-
ing to the configuration checklist that follows.
ITEMS NEEDED FOR CONFIGURATION

The number of CS440s in the system.

The local address (111, 112, etc.) for each unit.

The metafile generated by the CS440 tool for each unit

The connection to the DMS: Cerloop, CDI-Net, or NK8000.
Note: The CDI-Net/NK8000 requires a serial line available on the gateway.

Plug-ins needed:
– Plug-in #350401.
This is installed during the software setup procedure. You can check that the
Plug-in is actually available using the Composer Plug-in Installer in the
DMS8000 start menu.
CONFIGURING A CS440

1. Add the folder(s) required for identifying the location of the CS440 in the project
structure tree
p. 188

2. Add the CS440 syste
m node to the new folder
p. 188

3. Set the CS440 Lo
cal Address and Vitality Timer
p. 188

4. Import the CS440 m
etafile
p. 189

5. Link the CS440 to the n
etwork (Cerloop, CDI-Net, or NK8000)
p. 189

6. Repe
at steps above for all the CS440s in the project.