[en] Instructions for installation and use EA6..GH17., EA6..GE17., EA6..GF17., EA6..GN17., EA6..
($ *+ ($ *( ($ *) ($ *1 ($ *) * Ú Table of contents alondustifr[e]Ice Safety precautions..................................................................... 3 Causes of damage .............................................................................4 Environmental protection ......................................
: Safety precautions Please read this manual carefully. Please keep the instruction and installation manual as well as the appliance certificate in a safe place for later use or for subsequent owners. Check the appliance for damage after unpacking it. Do not connect the appliance if it has been damaged in transport. Only a licensed professional may connect appliances without plugs. Damage caused by incorrect connection is not covered under warranty. This appliance is intended for domestic use only.
Causes of damage Caution! ■ ■ Rough pot and pan bases scratch the ceramic. ■ Avoid boiling pots dry. This may cause damage. ■ ■ Damage can occur if hard or pointed objects fall on the hob. Aluminium foil and plastic containers melt on hot hotplates. Oven protective foil is not suitable for your hob. Never place hot pots or pans on the control panel, the display area or the surround. This may cause damage.
Hotplate and residual heat indicators The hotplate and residual heat indicators e light up when a hotplate is warm: ■ Hotplate indicator - during operation, shortly after you have switched on a hotplate. ■ Residual heat indicator - after cooking, when the hotplate is still warm. You can use the residual heat to save energy, e.g. to keep a small dish warm or to melt chocolate. Setting the hob This section informs you how to set the hotplates.
Cleaning and care The information in this section provides help on how best to care for your hob. Suitable maintenance and cleaning products can be purchased from the after-sales service or in our e-Shop. Ceramic Clean the hob after each use. This will prevent spills from burning onto the ceramic. ■ Abrasive sponges ■ High-pressure cleaners or steam jet cleaners Ground-in dirt can be best removed with a glass scraper, available from retailers. Please note the manufacturer's instructions.
Installing the hob Connecting the hob Do not trap cables during installation. Push the hob in until it locks into place. The cooker or control unit should be connected to the mains, but switched off. 6 1 Worktop cut-out, 500 mm deep: 1. Mark the centre of the cut-out 1. Insert the cooker until the socket is accessible. 2. Screw the PE conductor (green/yellow) for the hob to the < earthing point of the cooker. 3. Plug in the hotplate connector on the cooker.
Siemens-Electrogeräte GmbH Carl-Wery-Straße 34 81739 München Germany *9000715096* 9000715096 921026