Operation Manual

en Wipe protection
18
Setting procedure
Select the appropriate temperature setting from the
table. Place the empty frying pan on the hotplate.
1. Select the hotplate. Touch the Õ symbol.‘ lights
up on the display.
2. Within the next 10 seconds, select the required
temperature setting from the settings range.
The function has now been activated.
The p temperature symbol will remain lit until the
frying temperature has been reached. An audible
signal sounds and the temperature symbol goes out.
Notes
■ Turn the food so that it does not burn.
■ The hotplate must be selected in order to display the
temperature indicator p and the temperature setting.
Switching off the frying sensor
Select the hotplate and touch the Õ symbol. The
function is deactivated.
kWipe protection
Wipe protection If you wipe over the control panel while the hob is
switched on, settings may be altered. To avoid doing
this, you can use the hob's "Lock control panel for
cleaning" function.
To activate: Touch the
Ñ symbol. An audible signal
sounds. The control panel is locked for 35 seconds.
You can now wipe over the surface of the control panel
without altering any settings.
To deactivate: The control panel will be unlocked once
35 seconds have elapsed. To release the function early,
touch the
Ñ symbol.
Notes
■ An audible signal sounds 30 seconds after
activation. This indicates that the function is about to
finish.
■ The cleaning lock does not lock the main switch. The
hob can be switched off at any time.
bAutomatic safety cut-out
Automatic safety cut-out If a hotplate operates for an extended period and no
settings are changed, the automatic safety shut-off is
activated.
The hotplate stops heating. ”, ‰ and the residual heat
indicator œ or • flash alternately in the hotplate display.
When you touch any symbol, the display switches off.
The hotplate can now be set again.
The point at which the safety shut-off becomes active
depends on which heat setting has been set (after 1 to
10 hours). .