Instruction manual

3. Preparation before Machine setup
3.1 Foundation Requirement…………………………………………………... 3-1
3.2 Surrounding Requirement…………………………………………………. 3-2
3.3 Power Source Requirement…...…………………………………………… 3-4
3.3.1 Power Specification…………………………………………………… 3-4
3.3.2 Oil Specification………………………………………………………. 3-5
3.3.3 Air Specification……………………………………………………… 3-6
4. Transportation
4.1 Requirement of equipment….……………………………………………... 4-1
4.2 Marking on Wooden Case………………………………………………… 4-2
4.3 Unpacking Machine……………………………………………………….. 4-3
4.4 Moving Machine after Unpacking………………………………………… 4-4
4.4.1 Confirming Fixed Bracket on Machine…………….…………………. 4-4
4.4.2 Fork Lifting Machine…………………………………………………. 4-5
4.5 Relocating of Machine…………………………………………………….. 4-7
5. Installation
5.1 Machine Installation….……………………..……………………………... 5-1
5.2 Power On Machine…………………………...…………………………… 5-2
5.2.1 Cable Connection……………………………………………………... 5-2
5.2.2 Inspection before Power On…………………………………………... 5-3
5.2.3 Inspection after Power On…………………………………………….. 5-4
5.3 Level Adjustment………………………………………………………….. 5-6
5.4 Test-cutting……………………………………………………………...… 5-7
5.4.1 Checklist before Test-cutting…………….…………………...………. 5-7
5.4.2 Warming up machine…………………………………………………. 5-8
5.4.3 Testing-Cutting………………………………………………………... 5-9
6. Operation Instruction (please refer to operation manual)
7. Maintenance
＆
Cleaning
7.1 Daily Maintenance Procedures.………….....……………………………... 7-1
7.1.1 Daily Inspection after Operation…………………………………….... 7-4
7.2 Monthly Maintenance Procedures………………..……………………….. 7-6
7.3 Periodic Maintenance Procedures…………………..…………………...… 7-7
7.3.1 Check List…………….…………………………..…………...………. 7-7
7.3.2 Cleaning Lubricator Tank……………………………….……………. 7-8
7.3.3 Cleaning Hydraulic Tank……………………………………………... 7-12
7.3.4 Cleaning Coolant Tank………………………………………………... 7-13
7.3.5 Cleaning Air Filter Regulator…………………………………………. 7-14