Instruction manual

5-6
5.3 Leveling Adjustment
The machine must be adjusted level and accuracy very
carefully, because the first installation has a huge influence to
the machine's accuracy and life.
1) Take the level adjustment plate and
then put level gauge on.
2) Example:
A point: Both X axis and Z axis are
on original point.
B point: X=0.000  Z=-250.000
C point: X=0.000  Z=-500.000
3) Please change the operation mode to
manual operation mode, move Z
axis direction, from A point via B to
C point, move forward and
backward to check level gauge's
readout variation amount, then
adjust the foundation bolts
accordingly.
4) It's most important to level on Z
axis direction accurately by
adjusting the foundation bolts till
the allowed readout.
5) Further, reverse the level gauge
direction to check if level is
concave, convex or inclined which
should not be allowed because
accurate foundation level will do
much good for a machine.
6) After right and left level adjustment
is done, check front and back level,
adjust till all level is complied to
allowed accuracy.
7) After adjustment, push the water
tank back to the machine bottom,
and add coolant into the tank till the
water up to middle level line.
 If the machine is with chip
conveyor, it is also necessary to
mount it.
 Caution: 1. After level adjustment, it must be sure that all of foundation
screws and its locknuts are tight. (Only that can make machine's
eight endured evenly and totally by foundation screw. Thus,
machine can be more steady.)
2. Level precision should be 0.04 mm/M (0.0005 in/ft).