Operation Manual

Gas burners en
7
Accessories
Depending on the model, the hob may include the
following accessories. These can also be acquired from
the Technical Assistance Service.
--------
Code
The manufacturer accepts no liability if these
accessories are not used or are used incorrectly.
ÄGas burners
Gas burners Switching on manually
1. Press the control knob for the selected burner and
turn it anticlockwise to the highest power setting.
2. Hold an igniter or a naked flame (such as a lighter or
a match) against the burner.
Automatic ignition
If your appliance has automatic ignition (ignition plugs):
1. Press the control knob for the selected burner and
turn it anticlockwise to the highest power setting.
Sparks are produced on all burners while you are
pressing and holding the control knob. The burner
ignites.
2. Release the control knob.
3. Turn the control knob to the required position.
If the burner does not ignite, switch it off and repeat the
steps described above. This time, hold the control knob
down for longer (up to 10 seconds).
:Warning – Risk of deflagration!
If the burner does not switch on after 15 seconds,
switch off the control knob and open the door or
window in the room. Wait at least a minute before
igniting the burner again.
Note: It is important to keep the appliance clean. If the
ignition plugs are dirty, this may cause ignition faults.
Clean the ignition plugs regularly with a small non-
metallic brush. Take care to prevent the ignition plugs
from suffering any heavy knocks.
Safety system
Your hob is equipped with a safety system
(thermocouple) that cuts off the gas when the burners
are accidentally switched off.
To ensure that this device is active:
1. Switch on the burner as usual.
2. Without releasing the control knob, press and hold it
down firmly for 4 seconds after lighting the flame.
Switching off a burner
Turn the corresponding control knob clockwise to the 0
setting.
A few seconds after the burner is switched off, a sound
(thud) will be produced. This is not a fault - this means
that the safety device is no longer operating.
Warnings
It is normal to hear a soft whistling noise while the
burner is operating.
When first used, it is normal for the burner to give off
odours. This does not pose any risk and does not
indicate a malfunction. They will disappear in time.
Additional wok pan support
Only for use on wok burners
with pans with a round base.
The additional wok pan support
should be used to prolong the
appliance's useful life.
Additional support for
espresso makers
Only when using cookware with
a base less than 12 cm in diam-
eter on the smallest burner.
Simmer Cap
Lid specially designed to cook at
minimum power. For its use, the
Simmer Cap needs to be placed
on the auxiliary burner cap.
HZ298108 Wok attachment: Cast iron (mini-wok
burner)
HZ298107 Additional wok pan support: cast iron
(4-5 kW)
HZ298110 Additional wok pan support: steel enamel
HZ298114 Additional coffee maker support
HZ211310 Simmer Cap