Operation Manual
48
en
Empty drip tray
Replace drip tray
● Empty the drip tray 23 and reinsert it.
The appliance is ready for use again.
calc‘nClean
Duration: approx. 36 minutes.
calc‘nClean combines the separate
functions of descaling and cleaning.
If both programmes are due to be run
soon, the espresso machine automatically
suggests this service programme.
Cleaning and service
Short rinse
milk system
calc‘nClean
start
The start button 8 ashes while the differ-
ent calc‘nClean processes are running. The
gures on the top right indicate the progress
of the programme.
Important: If there is a water lter in the
water tank 11, it needs to be removed
before the service programme is run.
● Press the à button 3.
calc‘nClean
start
● Press the start button 8; the display 5 will
guide you through the programme.
Empty drip tray
Replace drip tray
● Empty the drip tray 23 and reinsert it.
● Swivel the coffee outlet 9 to the right until
it clicks into place.
Place 1 l container
Place suction pipe in container
start
● Place a container with a capacity of at
least 1 l under the milk frother 10.
● Place the end of the suction pipe 10d in
the container.
● Press the start button 8.
Cleaning
Open powder compartment
● Open the powder compartment 18.
Insert Siemens cleaning tablet
and close drawer
● Drop a Siemens cleaning tablet in the
drawer 18 and close.
Remove filter
start
Info: If the water lter is activated, the dis-
play will prompt you to remove the lter,
then press the start button 8 again.
Add 0.5 l water and descaler
start
● Pour lukewarm water into the empty
water tank 11 up to the “0.5 l” mark and
then dissolve 1 Siemens descaling tablet
TZ80002 in it. When using TZ60002,
2 tablets must be dissolved.
● Press the start button 8. The descaling
programme now runs for about
20 minutes.
Descaling
Not enough descaling fluid.
Refill fluid
start
Info: If there is not enough descaling solu-
tion in the water tank 11, the corresponding
prompt is displayed. Pour in descaling solu-
tion and press the start button 8 again.