- enhanced real-time ethernet controller User Manual

No. Signal
Name
Alternative
Function 1
Alternative
Function 2
Alternative
Function 3
I/O
(Reset)
Pull- PIN
No.
Comment
General Purpose I/O / I/O
23 GPIO22 SPI1_SFRMIN DBGACK B/I/O/(I) up F10 GPIO or SPI1 (I) or
Debug (O)
This GPIO is used as
chip select when
booting from Nand
Flash or SPI ROM.
24 GPIO23 SPI1_SCLKIN Reserved B/I/O/(I) up D10 GPIO or SPI1 (I)
This GPIO is used as
chip select when
booting from SPI Flash
or SPI EEPROM.
25 GPIO24 PLL_EXT_IN_N B/I (I) up B11 GPIO or MC_PLL (I)
26 GPIO25 TGEN_OUT1_N
*1
B/O/(I) up B9 GPIO or MC_PLL (O)
27 GPIO26 TGEN_OUT2_N B/O/(I) up A7 GPIO or MC_PLL (O)
28 GPIO27 TGEN_OUT3_N B/O/(I) up B10 GPIO or MC_PLL (O)
29 GPIO28 TGEN_OUT4_N B/O/(I) up F9 GPIO or MC_PLL (O)
30 GPIO29 TGEN_OUT5_N B/O/(I) up E9 GPIO or MC_PLL (O)
31 GPIO30 TGEN_OUT6_N B/O/(I) up B8 GPIO (interrupt-
capable) or MC_PLL
(O)
32 GPIO31 DBGREQ B/I (I) up E8 GPIO (interrupt-
capable) or DEBUG (I)
*1 For an IRT application pin GPIO25 is default parameterized as alternate function1 (TGEN_OUT1_N). A
synchronous clock is issued at this pin. During the certification process of a PROFINET IO DEVICE with IRT
functionality this pin has to be accessible from outside (mandatory).
Different GPIO’s are used on the Evaluation Board EB200. See Dokument /14/ Table 6.
1.5.2 JTAG and Debug
No. Signal
Name
I/O
(Reset)
Pull- PIN
No.
Comment
Debug / JTAG (BOUNDARY SCAN)
33 TRST_N I (I) U10 JTAG Reset
34 TCK
I (I)
up W7 JTAG Clock
35 TDI
I (I)
up U9 JTAG Data In
36 TMS
I (I)
up V7 JTAG Test Mode Select
37 TDO O (O) V9 JTAG Data Out
38 SRST_N B (O) up V8 Hardware Reset
39 TAP_SEL I (I) up W8 Select TAP Controller:
0: Boundary Scan TAP Controller
selected
1: ARM-TAP Controller selected
or Scan Clock (Scan mode)
1.5.3 Trace Port
No. Signal
Name
I/O
(Reset)
Pull- PIN
No.
Comment
Trace Port/Other
40 TRACECLK B (O) AB4 ETM Trace Clock
41 Reserved I (I) up U19 Connect pin to GND
Copyright © Siemens AG 2007. All rights reserved. 13 ERTEC 200 Manual
Technical data subject to change Version 1.1.0