Technical data

36 SIMATIC ET 200pro

Interface modules for PROFIBUS

The interface modules (IMs) for PROFIBUS can be combined

with three different modules for connecting the bus and pow-

er supply.

All connection modules for PROFIBUS have visible address

setters that allow the addresses to be easily read as well as a

selectable terminating resistor. The integrated T functionality

supports the start-up of partial segments and uninterrupted

bus communication in the event of a servicing requirement.

■ Direct connection with cable gland: For up to 16 A elec-

tronic load and a conductor cross-section of up to 2.5 mm².

■ ECOFAST (Energy and Communication Field Installation

System) – The standardized Siemens connection technique

for cabinet-free distribution is based on hybrid cables for

bus signals and power supply.

■ M12, 7/8'': The familiar connection method with widely im-

plemented connector standard.

Interface

modules

IM 154-1 DP

IM 154-2 DP HF

Protocol PROFIBUS DP

Transmission rate, max. 12 MBit/s

Firmware Update via PROFIBUS

Dimensions

(with connection module)

90 x 130 x 173 mm

with CM IP DP M12, 7/8"

90 x 130 x 120 mm

with CM IP DP directly

90 x 130 x 80 mm

with CM IP DP ECOFAST

Order No. group 6ES7 154-1.

6ES7 154-2.

PROFIBUS interface module,

ECOFAST connection

PROFIBUS interface module, M12,

7/8" connection

PROFIBUS interface module,

with direct connection