Installation Instructions

Siemens Industry, Inc.
Building Technologies Division
P/N A6V10335926_a_en2
FHD2001, FHD-2002 and FHD2003 Doors are for indoor use only in dry environments.
The outer door consists of the door frame and either one or two windows (one for
the FHD2001/FHD2002 and two for the FHD2003). Each window has a panel that is
secured to the door with 10-32 lock nuts. The outer door is attached to the backbox
by hinge pins and secured to the backbox by a keyed latch.
INSTALLATION The installation of the outer door is typically done after the inner door is installed.
Install the Outer Door: 1. Insert the hinge pins on the outer door into the hinges on the backbox.
2. Install FHD2006-U1 Clear Window(s), as required, in the opening(s) on the
outer door. The clear window installs in only one way. Secure in place with
the eight #10-32 lock nuts provided. Refer to Figure 2.
FHD2003
FHD2006
#10-32
LOCK NUTS
8 PLACES
Figure 2
Installing the FHD2006 Clear Window
3. A ground strap comes installed on the inside of the FHB2001 or FHB2002
backbox. Place the free end of the ground strap between the two #10-32
kep nuts on the stud located on the inside of the FHD2001, FHD2002 or
FHD2003 outer door and secure in place. On the FHD2001 door, the stud is
located in the top right inside corner. On the FHD2002 and FDH2003 doors,
the stud is located on the inside right side of the door near the center (Refer
to Figures 3 and 4.)
4. Close the outer door and secure with the key latch.