Installation Instructions

2. The manual station is programmed by using
the SIEMENS Model FPI-32 Programmer/
Tester. Connect the MSI-30BC to the
Programmer/Tester by using the cable
provided with the Programmer/Tester.
NOTE: The connection from the FPI-32 to
the MSI-30BC is not polarity sensi-
tive. However, connection from the
Control Panel to the MSI is polarity
sensitive.
3. Following the instructions given in the FPI-32
Programmer/Tester Manual, P/N 315-090077,
program the MSI-30BC to the desired address.
4. Record the device address on the nameplate
label located on the MSI-30BC housing.
(See
Figure 3.)
5. Distribute the manual station boxes through-
out the protected area so that they are
unobstructed, readily accessible, and located
in the normal exit path.
6. Place the manual station according to the
regulations of the authorities having
jurisdiction.
For surface mounting, mount the backplate
to a Model SB-5R Backbox as shown in
Figure 3.
For flush mounting, mount the backplate to
a user supplied single gang switchbox.
CAUTION: Do not overtighten the screws.
Overtightening may distort the
backplate.
7. Install the MSI-30BC. (Refer to Figure 3.)
8. Wire the MSI-30BC to the System (Refer to
Figure 2 for proper connections).
P/N 315-093345-4
Figure 3
Mounting Data