Installation Instructions
Siemens Building Siemens Building
Siemens Building Siemens Building
Siemens Building
TT
TT
T
ecec
ecec
ec
hnologieshnologies
hnologieshnologies
hnologies
Fire SFire S
Fire SFire S
Fire S
afetyafety
afetyafety
afety
P/N 315-034468-2
Installation Instructions
Model CAB-COVER
Cover for Small CAB1R, Medium CAB2R
and Large CAB3R Enclosure Backboxes
CAB-COVER
CAB1R
NUT
STUD
SLOT
SLOT
INTRODUCTION The Model CAB-COVER from Siemens Building Technologies, Inc. is used as a
protective cover over the ventilation holes in the top of CAB1R, CAB2-BB/-RB and
CAB3-BB/-RB enclosures.
CAB-COVER is for indoor use only in dry environments.
INSTALLATION Refer to Figure 1 for a typical CAB-COVER installation.
1. Remove the two nuts from the studs on the CAB-COVER.
2. Position the CAB-COVER over the top of the CAB enclosure, lining up the
two studs on the CAB-COVER with the two slots closest to the front of the
CAB opening. Secure the CAB-COVER in place with the two nuts.
The CAB-COVER is installed correctly when the side facing the back of the enclosure
is open.
Figure 1
Typical CAB-COVER Installation