User Manual

2
Siemens Schweiz AG
A6V11387243_en
--
_a
Building Products 2020-07-07
Use
This product must only be used with Sinorix
TM
fixed automatic extinguishing systems.
Functions
A test coupling joint consists of a connection plug and a connection socket. The socket is
connected to the pilot piping of the extinguishing installation. A discharge hose is connected
to the test cylinder and screwed on the plug. The plug is then inserted in the socket to
connect the test cylinder to the pilot piping. Both components should not be connected under
pressure.
Type summary
Item Description Item Description
1 Connection socket
(A5Q00036887)
2 Connection plug (A5Q00036888)
Notes
Safety
This product may only be installed by Siemens-authorized specialized installers, with
experience in the design, installation and maintenance of automatic extinguishing systems.
During installation, it must be ensured that:
● this product is installed in compliance with the accident prevention regulations and
national regulations in force,
● this product is used as intended,
● any danger is avoided,
● Siemens requirements are met (assembly instructions, technical instructions,
commissioning, and operating instructions),
● the operators have received and understood the information related to this product.
At commissioning, ensure compliance with the legislation in force, technical regulations and
safety instructions.
Failure to comply with Siemens' instructions may result in serious bodily injury or significant
property damage, for which Siemens cannot be held liable.
Siemens reserves the right to make technical modifications and/or improvements at any
time.
Mounting
● Screw the socket on a T-piece within the pilot piping and tighten it using a 19 mm
wrench. Tightening torque: 10 Nm.
● Connect the plug to the hose of the test cylinder.
● Insert the plug in the socket.