Operating Instructions

SINAMICS G120 CU230P-2 Control Units
List Manual, 04/2018, A5E33838102
865
Index
J
Jogging, 630
K
Kp/Tn adaptation
Technology controller, 728
L
Linked parameters, 13
List
Abbreviations, 847
ASCII table, 844
Binector inputs (BI parameters), 534
Binector outputs (BO parameters), 538
Command data sets, 524
Connector inputs (CI parameters), 536
Connector outputs (CO parameters), 540
Connector/binector outputs (CO/BO parameters),
543
Drive data sets, 526
Faults and alarms, 763
Message ranges, 761
Motor data sets, 531
Parameter ranges, 23
Parameters for quick commissioning, 547
Parameters for write protection and know-how
protection, 545
Parameters, all, 26
Power unit data sets, 533
List of abbreviations, 847
M
MDS, Motor Data Set, 18
Message class, 756
Message value, 756
Motorized potentiometer, 726
Multi-zone control, 697
N
Name
Alarm, 756
Fault, 756
Normalization, 18
Number
Alarm, 755
Fault, 755
Parameters, 13
Number range
Alarms, 761
Faults, 761
Parameters, 23
Number ranges of faults and alarms, 761
O
OFF1, 753
OFF1_DELAYED, 753
OFF2, 753
OFF3, 753
P
Parameter
Normalization, 18
Parameters
Access level, 15
Bit field, 21
Calculated, 15
Can be changed, 17
Command data sets, 524
CU/PM variants, 14
Data type, 16
Dependency, 21
Description, 20
Drive data sets, 526
Dynamic index, 18
Full name, 14
Function diagram, 20
Index, 13, 21
Linked parameters, 13
List for quick commissioning, 547
List of all parameters, 26
List of the binector inputs, 534
List of the binector outputs, 538
List of the connector inputs, 536
List of the connector outputs, 540
List of the connector/binector outputs, 543
Motor data sets, 531
Number, 13
Number range, 23
Parameter values, 20
Power unit data sets, 533
Recommendation, 20
Safety guidelines, 21
Short name, 14
Unit group, 18
Unit selection, 18
Values, 20
Password for access level 4, 15
PDS, (Power unit Data Set), 18
PROFIBUS, 577
PROFIdrive, 577
PROFIenergy, 574
PROFINET, 577
pxxxx, 13
Q
Quick commissioning (parameters), 547