Operating Instructions

ManualsBrandsSiemens ManualsVariable Speed DriveSINAMICS PM230 (IP20) Power Module Getting Started Guide

List of parameters

Parameters

1-31

SINAMICS G120 CU230P-2 Control Units List Manual (LH9), 01/2013

[18] = Depletion layer 6

[19] = Reserved

Notice: Only for internal Siemens troubleshooting.

Note: The value of -200 indicates that there is no measuring signal.

r0037[0]: Maximum value of the inverter temperatures (r0037[5...10]).

r0037[1]: Maximum value of the depletion layer temperatures (r0037[13...18]).

r0037[2]: Maximum value of the rectifier temperatures (r0037[11...12]).

The maximum value is the temperature of the hottest inverter, depletion layer, or rectifier.

Description: Displays the smoothed actual power factor. This refers to the electrical power of the basic fundamental signals at

the converter output terminals.

Notice: For infeed units, the following applies:

For active powers < 25 % of the rated power, this does not provide any useful information.

Note: Smoothing time constant = 300 ms

The signal is not suitable as a process quantity and may only be used as a display quantity.

Description: Displays the energy values at the output terminals of the power unit.

Index: [0] = Energy balance (sum)

[1] = Energy drawn

[2] = Energy fed back

Dependency: Refer to: p0040

Note: Re index 0:

Sum of the energy drawn and energy that is fed back.

Description: Setting to reset the display in r0039 and r0041.

Procedure:

Set p0040 = 0 --> 1

The displays are reset and the parameter is automatically set to zero.

Dependency: Refer to: r0039

r0038 Power factor smoothed / Cos phi smooth

Access level: 4 Calculated: - Data type: FloatingPoint32

Can be changed: - Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: 6799, 8850, 8950

Min Max Factory setting

- - -

r0039[0...2] Energy display / Energy displ

Access level: 2 Calculated: - Data type: FloatingPoint32

Can be changed: - Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: -

Min Max Factory setting

- [kWh] - [kWh] - [kWh]

p0040 Reset energy consumption display / Energy cons reset

Access level: 3 Calculated: - Data type: Unsigned8

Can be changed: U, T Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: -

Min Max Factory setting

0 1 0