User Manual

Basic Operator Panel 2 (BOP-2)
Operating Instructions, 02/2016, A5E37143404B AA
33
Parameters
9
Parameter menu
The Parameter menu allows access to view and change the parameters of the Inverter.
There are two filters available to assist in the selection and searching of all the Inverter
parameters, these are:
● Standard filter - this filter gives access to the most commonly used parameters for the
specific type of Control Unit to which the BOP-2 is fitted.
● Expert filter - this filter gives access to all the Inverter parameters.
The parameters can be addressed by the following methods:
● Parameter number
● Parameter number and index number
● Parameter number and bit number
● Parameter number, index number and bit number.
NOTICE
Action on fault during parameter editing
If a fault occurs during parameter editing, the fault screen must be exited by pressing
or in order to allow the editing cycle to be completed.
On a Safety Parameter Reset the Inverter MUST be power-cycled after the fault screen
has been exited.
To access the standard or expert parameter filters, the actions in the following figure should
be performed.