User Manual

62
Commissioning a KNX system
via Ethernet (WLAN)
In every GAMMA instabus project, the devices are commis-
sioned after their installation. First, the physical addresses
must be assigned. To do this, select the device in ETS on
the notebook and press the programming key on the
device. If you have various devices at different places such
as flush-mounted bus coupling units, this can result in
intensive walkways. That’s the reason why two people
usually perform the commissioning. You can save yourself
this considerable extra work by connecting your notebook
wirelessly to the KNX via WLAN. This lets you move about
freely during commissioning ‒ just take your notebook with
you to each room. Any errors such as mixup of devices due
to misunderstandings are ruled out.
KNX device
WLAN-enabled notebook
WLAN router
KNX device
KNX device
WLAN
LAN (Ethernet cable)
IP interface
KNX