User Manual

M MMM M M
+
M M
Room model
The room model is the starting point in the display and
operation section of the case, which is controlled by the
mounted Function and Operation Modules (FOMs).
The room model in the GAMMA Training Kit enables you to
show all KNX functions such as:
• Lighting group A & B above a meeting table
• Lighting group C in a meeting room
• Lighting D in the staircase
• Office room lighting E and F
• Blinds on four sides M, M, M and M
• Wind sensor simulation wind / no wind
• Window simulation: window open / closed
• Heating radiator G
• Cooling element H
In the the basic configuration of the demo cases and the
mount
ed FOM are not predefined but can be extended
and ex-changed with any optional FOMs. There are three
module places left for your own configuration. Only the
module  or  is a minimum requirement in order to
control the window and wind simulation. In the case of
the unassembled modules: the required devices need to
be ordered separately. These customized modules can be
connected to a wiring connector socket block in the space
behind these modules.
The KNX solutions and applications in the GTK . depend on
the mounted FOMs. A module consists of a  x  mm
plate with one or more installed KNX devices. The module
M DALI has different dimensions and is mounted in the
distribution board area.
All modules can be ordered without a device and with an
installed GAMMA device. For the unassembled modules,
the KNX devices need to be ordered separately. In this way,
the GAMMA Training Kits are flexible in their usage and can
be upgraded individually.
oder
Operation and Function Module
to extend the demo case