User Manual

Input devices
Binary input devices
Combination actuators
119
Siemens Switzerland Ltd www.siemens.com/gamma 2020
Smart Infrastructure
3
Combi switching actuator 8 x AC 230 V, 16 A, 8 x binary inputs
 8 inputs AC/DC 12...230 V
 8 relay contact outputs
 Rated contact voltage AC 230 V
 Rated contact operating current 16 A, p.f. = 1
 Electronics power supply via an integrated power supply unit for AC 230 V
 Device functional even without bus connection or if bus voltage absent or bus communication
interrupted or not yet activated
 Push button to switch between bus and direct mode
 Push button for each output to switch the output in direct mode via a toggling function by a short
actuation and for changing the output mode between remote control relay and time switch relay by
holding down the push button for some seconds
 Device preset at the factory for direct switching of an output through a toggling function via the input
of the same name
 Selectable function for each input when using the Engineering Tool Software (ETS):
 Switching status / binary value transmission
 Switching, short / long operation
 Single button dimming, single button sun protection control, 1-button group control (sequence
control)
 1-bit scene control
 8-bit scene control, 8-bit value, edge-triggered, 8-bit value, short / long operation
 16-bit floating point value, edge-triggered, 16-bit value, short / long operation, 16-bit value, edge-
triggered, 16-bit floating point value, short / long operation
 Selectable function for each pair of inputs:
 2-button dimming with stop telegram or with cyclical sending
 2-pushbutton shutter/blind control
 Selectable blocking / releasing of each input via a corresponding blocking object
 Sending of the input objects after a change of status
 Selectable logic operation (AND/OR) for one input with a further communication object and with
variable start value of the logic operation at bus voltage recovery
 Setting by means of the ETS, whether all outputs are to be configured identically or individually
 Selectable mode for each output (normal mode, time switch mode)
 Optional addition of a night mode object for each output for time-limited switching On of the output
(and hence the illumination) at night
 Variable On and Off delay times for each output
 Variable On period in night mode or in time switch mode
 Selectable warning signal prior to imminent switching-off by means of three-times short off and on
switching (flashing) in night mode or in time switch mode
 Optional status object per output for status reporting
 Sending of status objects on request and/or automatically after a change
 Integrated 8-bit scene control and linking of each output with up to 8 scenes
 Selectable switching state for each output at mains or bus power failure as well as after bus or mains
voltage recovery
 Integrated bus coupling unit with only half a standard bus load
 Bus connection via bus terminal or contact system to data rail
 Modular installation devices for mounting on TH35 EN 60715 mounting rail
Data sheet
A6V10416148
Rated voltage
AC 230 V
Rated current
16 A
Number of channels
8
Number of inputs potentialfree
8
Dimension width (1 MW = 18 mm)
8 MW
N 502/02
Stock no.
Product no.
5WG1502-1AB02
N 502/02