User Manual

Solar protection, anti-glare protection, utilization of daylight
Anti-glare/solar protection actuators
179
Siemens Switzerland Ltd www.siemens.com/gamma 2020
Smart Infrastructure
6
Solar protection actuator
 For control of drives with a motor for AC 230 V
 Electrically interlocked relays to reverse the direction of rotation
 Rated contact operating voltage AC 230 V
 Rated contact frequency: 50/60 Hz
 Rated contact current: 6 A
 Electronics for detection of the actuation of an electromechanical and electronic limit switches
 Automatic travel time determination via current measurement
 Per actuator channel direct operation function on the device for driving solar protection up/down, stop
command and slat adjustment
 Two status LEDs per actuator channel to indicate the direction of travel and an override
 Button on the device front for deactivation of the direct mode operation and LED to indicate activation
direct mode operation
 Maintenance-free terminals for connection and through-wiring of untreated single-core, stranded or
multi-core conductors, 0.5 ... 2.5 mm²
 Two terminals per actuator channel for motor connection (up, down)
 At least one phase connection terminal for two actuator channel each
 Bus-powered electronics
 Housing: plastic, color RAL 7035 (light grey), N-system
 DIN rail mounted device for mounting on rail TH35 according to DIN EN 60715
 Type of protection: IP 20
 Selectable operation mode blinds, shutter/awning, ventilation flap
 Per actuator channel motion commands for moving and stopping the solar protection or for
adjustment of blind slats
 Per actuator channel direct movement to a position of the sunblind and the blind slats
 Per actuator channel central movement of the solar protection in manual mode and automatic mode
and delay time for Up / Down
 Distinction between automatic and manual mode (position of the sunblind and blind slats) and
adjustable behaviour in sunshine
 Programming and recalling preset positions 1-4 and 8-bit scene control
 Adjustable behaviour in case of override (wind, rain, frost, lock, forced position, forced control, range
limitation)
 Adjustable reverse pause time and delay times of the drives
 Per actuator channel configurable state on bus voltage failure and start value on bus voltage recovery
 Adjustable transmission of status objects (direct operation, automatic operation, curtain and slat
position, travel, calibration travel time to end positions, overriding) on request, cyclically and/or upon
change
 Adjustable transmission time of the status objects after bus voltage recovery and transmission delay
between the status objects
 Surveillance of device function
Rated current
6 A
N 543D..1
Solar protection actuator, 4 x AC 230 V, 6 A, with end position detection
 DIN rail mounted device for mounting on rail TH35 according to DIN EN 60715
 all functions as N 543D..1
Data sheet
A6V11986596
Dimension width (1 MW = 18 mm)
4 MW
N 543D31
Stock no.
Product no.
5WG1543-1DB31
N 543D31
New Product