Data Sheet for Product

instabus EIB
Technical Product Information
September 2001
Push button AP 115 5WG1 115-3AB_1
Product and functional description
The push button AP 115 is available in the following
designs:
Neutral position, 1-fold, with window 5WG1 115-3AB01
Neutral position, 2-fold 5WG1 115-3AB11
Switch position, 1-fold, with window 5WG1 115-3AB21
Switch position, 2-fold 5WG1 115-3AB31
The push button AP 115 is a complete device from the
splash-proof DELTA fläche range and is suitable for
surface mounting with protection type IP 44. It consists
of housing, rocker(s) and a bus coupling unit.
Depending on the design (1-fold or 2-fold), single
rockers with a window or twin rockers without a window
are available.
Siemens AG AP 115, 4 pages Technical manual
There are also two LEDs which can either be used for
status display or as an orientation light (selectable). The
LEDs are supplied via the bus voltage. The LEDs are
however only visible externally in the 1-fold push button
with a window. It is therefore a good idea only to control
the LEDs with these devices.
In the neutral position variant, both the upper and lower
rocker contact can be operated (two switch contacts per
rocker); in the switch position variant, only the lower
rocker contact can be operated (one switch contact per
rocker).
The push button AP 115 can only function with an
appropriate application program i.e. the push button
consists of the device (hardware) and the application
program (software).
Using the ETS program (EIB Tool Software), the
application programs can be selected and the specific
parameters and addresses can be assigned.
Application programs
12 S1 On-off-toggle/Dim/Shu/Display 211001
• Single rocker for dimming, shutter control or
on/off/toggle
• LED for status display or as orientation light
12 S1 On-off-toggle/Display 210F01
• Single rocker for on/off/toggle
• LED for status display or as orientation light
12 S2 On-off-Toggle/Dim/Shu/Display 221001
• Twin rocker for dimming, shutter control or
on/off/toggle
• LED for status display or as orientation light
12 S2 On-off-toggle/Dim/Shu/Display 220F01
• Twin rocker for dimming, shutter control or
on/off/toggle
• LED for status display or as orientation light
Installation instructions
• The device can be used for permanent interior and
outdoor installations and wherever the protection type
IP 44 is required.
V
WARNING
• The device may only be installed and commissioned
by an authorised electrician.
• The device may not be connected to 230 V.
• It is not permitted to lead 230 V cables into the device
and/or loop them through the device.
• The device may be used in switch sockets, if VDE
approved devices have been used.
• The prevailing safety and accident regulations must be
observed.
• The bus coupling unit may not be opened. Any faulty
devices should be returned to the local Siemens office.
Automation and Drives Group
Electrical Installation Technology  Siemens2001 Update: http://www.siemens.de/installationstechnik
P.O.Box 10 09 53, D-93009 Regensburg Subject to change without prior notice
2.16.1.1/1