Data Sheet for Product

GAMMA wave
Technical Product Information
September 2007
Door/window contact wave AP 260 titanium white 5WG3 260-3AB11
brown 5WG3 260-3AB81
Technical Manual wave AP 260, 4 pages Siemens AG
Automation and Drives Group
Update: http://www.siemens.de/gamma © Siemens AG 2007 Electrical Installation Technology
Subject to change without prior notice P.O. Box 10 09 53, D-93009 Regensburg
2.20.3.1/2
Mechanical specifications
• Housing: plastic
• Dimensions (L x W x H): sensor: 87x36x27 mm
magnet: 40x10x10 mm
• Weight of sensor: approx. 65g (with battery)
• Fire load: approx. 800kJ
• Mounting: fixed with adhesive or screws
Electrical safety
• Pollution degree (according to IEC 60664-1): 2
• Protection (according to EN 60529): IP 20
• Overvoltage category (according to IEC 60664-1): III
• Device complies with EN 60669-2-1 and IEC 60664-1
Electromagnetic compatibility
Complies with
EN 301489, EN 300220
Environmental specifications
• Climatic conditions: EN 50090-2-2
• Ambient operating temperature: - 5 ... + 45°C
• Storage temperature: - 25 ... + 70°C
• Relative humidity (non-condensing): 5% to 93%
Certification
complies with
- standard
- radio frequency rf
- easy mode push button EP
CE norm
in accordance with the EMC guideline, low-voltage regu-
lations and the R&TTE regulations
SIEMENS AG hereby declares that the door/window
contact wave AP 260 is compliant with the basic re-
quirements and the other relevant instructions in EC Di-
rective 1999/5.
The CE declaration can be inspected at:
SIEMENS AG
Siemensstraße 10
D-93055 Regensburg
Installation instructions
Caution:
• The device may be used for interior installations and in
dry rooms only.
• The device may not be opened for warranty reasons.
• Occasionally the transmission range may be influ-
enced by structural conditions (e.g. reinforced con-
crete) or electric / electronic sources of interference.
• A
minimum distance of 1 m must be maintained be-
tween the
door-/ window contact wave and the relevant
receivers.
• Although the radio transmission is carried out in the
safe 868 MHz range, disruptions to the radio transmis-
sion cannot be excluded.
• This product is not suitable for security applications in
professional alarm systems.
Mounting
It
is advisable to attach the radio-controlled sensor to the
fixed
door-/ window frame and to attach the magnet di-
rectly to
the edge of the movable door or window. If the
sensor and magnet are fixed
to the top of the window,
even the tilting of the window is reliably detected and re-
ported (Diagram B1).
Diagram B1 Diagram B2
The mounting plate (C2) of the door/window contact (C1)
as well as the magnet (C3) can be fixed using the sup-
plied
adhesive strips or with screws if necessary. When
using the adhesive strips the ground must be clean and
non-greasy. It should be ensured that the SIEMENS
markings on the mounting plate and magnet lie on top of
each other as much as possible and that the distance
(gap) between the mounting plate and the edge of the
door or window is at least 3 mm but does not exceed 10
mm.
C1
C2
C3
min. 3 mm
max. 10 mm
Diagram C