Brochure
44 45
Commissioning assistant
Commissioning a
KNX/Ethernet system (WLAN)
In GAMMA instabus projects, the devices are commis-
sioned after installation. First, the physical addresses must
be assigned. To do this, select the device in ETS on the
notebook and press the programming key on the device.
If you have various devices at different places such as
flush-mounted bus coupling units, this can require inten-
sive walkways. That’s the reason why two people usually
perform the commissioning.
You can save yourself this extra work by connecting your
notebook wirelessly to the KNX bus via WLAN. This lets
you move about freely during commissioning ‒ just take
your notebook with you to each room.
Benefits
■
Wireless planning, configuration and diagnosis with
ETS (Version 3 or later)
■
Convenient commissioning via WLAN
■
Only one person is needed to commission the system
Follow these steps
■
Connect the IP interface to the KNX bus
■
Connect the WLAN router to the IP interface using
the Ethernet cable
■
Take the notebook along to the individual rooms
and commission the devices with ETS
You will need
■
An IP interface with an additional power supply
or Power-over-Ethernet, if necessary
■
WLAN router
■
WLAN-enabled notebook
■
ETS (Version 3 or later)
KNX device
Notebook WLAN-enabled
WLAN router
KNX device
KNX device
WLAN (wireless)
LAN (Ethernet cable)
IP interface
KNX