Brochure

54 55

Commissioning assistant

Using DALI luminaires with

easy KNX commissioning

Ballasts with a DALI interface are used in lighting controls,

e.g., to report lamp failure. The switch/dimmer actuator

now makes it possible to completely replace DALI devices

with GAMMA instabus devices without any knowledge of

DALI or DALI commissioning procedures.

The switch/dimmer actuator switches and dims eight

independent groups of ﬂuorescent lamps with dimmable

ballasts and DALI interfaces. Up to eight DALI ballasts can

be connected to each of the eight channels.

Beneﬁts

■

Individual lighting control

■

Flexible luminosity from 0 to 100 percent

■

High operating safety due to targeted shutdown

in the event of an error

■

Error messages for luminaire groups

Follow these steps

■

Connect the switch/dimmer actuator to the KNX bus

■

Connect each group of DALI ballasts to be controlled

jointly to one output of the switch/dimmer actuator

■

Conﬁgure each channel in ETS just as you would a

conventional actuator and program the device

You will need

■

Switch/dimmer actuator or KNX/DALI gateway

■

Dimmable ballasts with DALI interfaces

■

ETS (Version 3 or later)

DALI-EVG

Up to 8 DALI ballasts per channel

Switch/dimmer actuator or KNX/DALI gateway

KNX

DALI