Data Sheet for Product

PE400-1
Product
Specifications
APPLICATION
Leviton’s PE400-1 Power Extender allows a dimmers power handling capacity to be
extended to a full 1000W/VA on 120V input power. It allows a dimmer to dim or
switch a fully loaded circuit of electronic low voltage and incandescent loads only.
FEATURES & BENEFITS
• Works with electronic low voltage and incandescent
• Emulates the characteristics of the dimmer that it is connected to
in terms of dimming range and resolution
• Works with any Dimensions Multi-zone Controller/Dimmer to
extend load capacity for electronic low voltage loads on any zone
Leviton Mfg. Co., Inc.
59-25 Little Neck Pkwy • Little Neck, NY 11362-2591 • Tech Line: 1-800-824-3005 • Fax: [phone]
Visit our Website at: www.leviton.com
MOUNTING
All Power Extenders must have 4-1/2" spacing above
and below each unit for proper ventilation and heat
dissipation (refer to figure 3). Line voltage wiring
should be at least 6ft away from sound or electronic
equipment wiring. Mount Power Extender to wall box
with “TOP” facing up as follows: For Wall Box
Mounting (refer to figure 1), for Flush Mounting
(refer to figure 2) and for Panel Mounting (not
shown), proceed as follows:
a. The enclosure must be in
accordance with all local and
national electrical codes.
b. Leviton DOES NOT recommend
using a door to enclose the front
of a panel, since this restricts
airflow to the controls.
c. If mounting multiple controls in
an enclosure:
• Ambient timperature within an
enclosure “MUST REMAIN
BETWEEN”32
o
-104
o
F
(0
o
-40
o
C).
• If not mounting in a metal
enclosure, all units “MUST” be
mounted in a wall box.
d. To improve heat dissipation of
controls, remove the faceplate
from the unit.
PE400-1 Power Extender
1900 Box
Raised Cover
Mounting Screws
(4 Places)
Power
Extender
Power Extender
Wallplate
T
O
P
2 Gang Raised Cover
1900 Box
Raised Cover
Mounting Screws
(4 Places)
T
O
P
2 Gang Raised Cover
Power Extender
Wallplate
Power
Extender
Figure 2: Flush Mounting
4-1/2" (11.4 cm)
Minimum
4-1/2" (11.4 cm)
Minimum
Figure 3: Front View Spacing
Figure 2: Flush Mounting
Figure 1: Surface Mounting
4.50
2.06
2.80
4.72
PE400-1 Power Extender