Data Sheet for Product

PE100-1
Product
Specifications
APPLICATION
Leviton’s PE100-1 Power Extender allows a dimming
zone’s power handling capacity to be extended to a
full 1920W/VA on 120V input power. It allows a zone
to dim or switch a fully loaded circuit of incandescent
and magnetic low voltage loads only.
FEATURES & BENEFITS
• Works with incandescent, magnetic low voltage,
halogen or neon/cold cathode lighting
• Low-end trim available for setting the
minimum brightness level
• Emulates the characteristics of the dimmer
that it is connected to in terms of dimming
range and resolution
• Works with any Dimensions Multi-zone
Controller/Dimmer to extend load capacity
on any zone
PE100-1 Power Extender
1900 Box
Raised Cover
Mounting Screws
(4 Places)
Power
Extender
Power Extender
Wallplate
TOP
2 Gang Raised Cover
1900 Box
Raised Cover
Mounting Screws
(4 Places)
TOP
2 Gang Raised Cover
Power Extender
Wallplate
Power
Extender
1
Leviton Mfg. Co., Inc.
59-25 Little Neck Pkwy • Little Neck, NY 11362-2591 • Tech Line: 1-800-824-3005 • Fax: [phone]
Visit our Website at: www.leviton.com
JOB NAME:
JOB NUMBER:
CATALOG NUMBERS:
SPECIFICATION SUBMITTAL
Figure 2: Flush Mounting
MOUNTING
All Power Extenders must have 4-1/2"
spacing above and below each unit for
proper ventilation and heat dissipation
(refer to figure 3). Line voltage wiring
should be at least 6ft away from sound or
electronic equipment wiring. Mount Power
Extender to wall box with “TOP” facing up
as follows: For Wall Box Mounting (refer
to figure 1), for Flush Mounting (refer to
figure 2) and for Panel Mounting (not
shown), proceed as follows:
a. The enclosure must be in accordance
with all local and national electrical codes.
b. Leviton DOES NOT recommend using a
door to enclose the front of a panel, since
this restricts airflow to the controls.
c. If mounting multiple controls in an
enclosure:
• Ambient timperature within an enclosure
“MUST REMAIN BETWEEN”32
o
-104
o
F
(0
o
-40
o
C).
• If not mounting in a metal enclosure, all
units “MUST” be mounted in a wall box.
d. To improve heat dissipation of controls,
remove the faceplate from the unit.
TOP
TOP
4-1/2" (11.4 cm)
Minimum
4-1/2" (11.4 cm)
Minimum
Figure 3: Front View Spacing
Figure 2: Flush Mounting
Figure 1: Surface Mounting
PE100-1 Power Extender
2.06
(52.3 mm)
2.80
(71.1 mm)
4.72
(119.9 mm)
4.50
(114.3 mm)