User Manual

16/36
Siemens ET D1 · 2018/2019
Technical Information
Motion Detectors
DELTA reflex motion detectors, IP55
16
Pulse mode
The pulse mode is activated/deactivated by pressing the S2
pushbutton for longer than 3 s. In this operating mode, the load
is switched on for one second when it detects movement if the
brightness falls below the current brightness switching thresh-
old. There is then no further reaction to any movement for 9 s.
Note: By pressing the pushbutton for longer than 3 s, you can
switch between pulse mode and delay time mode.
The pulse mode is primarily used for controlling staircase light
ti
mers.
Select individual delay time
The required delay time is started by pressing the S2 pushbutton
for less than 3 s. By repressing the S2 pushbutton for less than
3 s, you can store the time between the first and second press
of the pushbutton as an individual delay time. The shortest pro-
grammable individual delay time is 5 s.
Comfort function
Comfort function through the use of optional switches or push-
buttons (requirement: device is in delay time mode - not in pulse
mode)
A general distinction is made between a long (> 2 s) and a short
(0.2 to 2 s) system interruption.
Technical specifications
Power supply
• Rated voltage 230 V AC, +/-10 %, 50/60 Hz
Terminals
• Solid conductors 1 mm² ... 4 mm², max. 2 x 2.5 mm²
• Stranded conductors (only with
end sleeve)
1 mm² ... 2.5 mm², max. 1 x 2.5 mm²
Electrical specifications
• Power loss Approx. 1 W
• Twilight sensor
From approx. 0.5 lux brightness-inde-
pendent mode
• Delay time
5 s ... 30 min
• Pulse mode
1 s ON/9 s OFF
• Test mode
2 s brightness-independent mode
Max. switching capacity
• 120° version
- Incandescent lamps 1000 W
- Fluorescent lamps (KVG)
8 x 58 W (uncorrected)
- Energy-saving lamps
4 unit
- Series fuse
Max. 10 A
• 290° and 290° IR version
- Incandescent lamps 2500 W
- Fluorescent lamps (KVG)
20 x 58 W (uncorrected)
- Energy-saving lamps
8 unit
- Series fuse
Max. 10 A
Mechanical specifications
• Enclosure Plastic (PC, ABS)
• Adjustment range of swivel arm
Max. 120°
• Dimensions (L x W x D)
180 x 86 x 74 mm
• Weight
235 g
• Degree of protection
IP55
• Range (mounting height
2.5 m/+22 °C)
- Version 120 Approx. 10 m
- 290° and 290° IR version
Approx. 16 m
• Mounting height
2 ... 4 m, ideally 2.50 m
Electrical safety
• Degree of protection (acc. to EN
60529)
IP55
• Overvoltage category
(acc. to IEC 60664-1)
III
• Device complies with
EN 60669-1 and EN 60669-2-1
Environmental specifications
• Storage temperature -30 ° ... +70 °
• Rel. humidity (non-condensing)
5 % ... 93 %
Approvals
• VDE certification Yes
• CE marking
Yes
• Compliance with EMC Directive,
Low Voltage Directive
Yes