User Manual

16/55
Siemens ET D1 · 2018/2019
16
Technical Information
Shutter/Blind Controls
sys shutter/blind control inserts (5TC1231)
Technical specifications
Dimensional drawings
Power supply Mains connection 230 V
Rated voltage: 230 V AC, 50 Hz
Outputs
• Output channel (UP/DOWN) 1
• Rated voltage
230 V AC, 50 Hz
• Rated current
8 A resistive load
• Switching capacity
1 motor, 1000 VA
• Max. duty ratio of the relay
120 s
• Switchover interval between
UP and DOWN operation
1 s
• Relay ON period for
STEP command
100 ms
• System interruptions
< 0.2 s are bridged
Terminals
The connections for the DELTA sys shutter/blind control insert comprise six screw terminals,
the following conductor/cross-sections are permissible:
• 0.5 … 2.5 mm² solid
• 0.5 … 1.5 mm² finely stranded with end sleeve without insulating collar (gas-tight crimp connection)
Caution: If the conductors need to be looped through, only conductors with max. 1.5 mm² can be used
Mechanical specifications
• Enclosure Plastic
• Dimensions
Modular width: 71 mm x 71 mm
mounting depth: 32 mm
• Weight
Approx. 75 g
• Fire load
Approx. 1000 kJ
• Mounting
Installation in device boxes 60 mm Ø, at least 40 mm deep complies with DIN 49073-1
Electrical safety
• Pollution degree
(acc. to IEC 60664-1)
2
• Degree of protection (acc. to EN
60529)
IP20
• Overvoltage category
(acc. to IEC 60664-1)
III
• Relay
µ contact
EMC requirements
According to EN 50090-2-2, EN 60669-2-1, EN 61000-6-3, EN 61000-6-1
Environmental specifications
• Resistance to climate EN 50090-2-2
• Ambient operating temperature
-5 … +45 °C
• Storage temperature
-25 … +70 °C
• Relative humidity
(non-condensing)
5 … 93 %
Approvals
VDE certification
CE marking
According to EMC Directive (residential buildings), Low Voltage Directive