User Manual

5 / 10
A6V10636150_en--_c Siemens
2018-01-11 Building Technologies
Mounting
Both ball valve and rotary actuator can easily be assembled at the mounting location. Neither
special tools nor adjustments are required.
Orientation
90°
471 6Z 16
90°
Cables must be easily accessible
Protection against weather, humidity and dirt
Protection against direct
sunlight and rain
Correct mounting position and cable connection
Protection only with
closed cover!
Installation
WARNING
No internal line protection for supply lines to external consumers
Risk of fire and injury due to short-circuits
● Adapt the line diameters as per local regulations to the rated value of the installed fuse.
Commissioning
When commissioning the system, check wiring and the functions of the rotary actuator.
Manual adjustment
The rotary actuator can be manually adjusted into any position between 0° and 90° by
pushing the gear train disengagement slider.
If a control signal from the controller is present, this will take priority in determining the
position after the slider is released.
For manual adjustment: Power off!
Maintenance
The actuators GDB..9E are maintenance-free.
G
SD..1A _Z07
IP54
IP54
G
D
.
.
9
E
_
J
0
2