Operation Manual

22
Starting the Installation Assistant
Gigaset 4170/4175isdn, A31008-G4170-B100-2-7619
Installations_assi.f
21.2.02
Step
by
Step
If this function is not supported by the service provider, the MSNs must be en-
tered manually; see next chapter.
Enter own numbers (MSNs) and name for the MSNs.
You can store up to 10 numbers. For easier identification, you can enter a name
for each number.
Confirm the prompt for entering the call number with [YES].
Confirm the prompt for entering the first MSN with [YES].
Enter the name and with
Z
move to Change call number, if required enter or
change call number and confirm with [
W
].
Select using [
Á
] and [OK]: Save entry.
You are prompted for the next MSN.
Setting the device type
The factory default for the TAE connections isTelephone. This means that even
without the handset, the base station is already in its standby state with a tel-
ephone (with tone dialling/DTMF) connected to Intern 21 or Intern 22. If you
wish to connect to another analog device (e.g. fax machine), the device type
must be changed ((see page 74)).
Select [YES] to confirm the prompt for setting the device type.
Select [YES] to confirm the prompt for the internal party.
Press [
Á
] and [OK] to select: (device type).
To confirm, press ».
To end the procedure select
Î
.
Allocations for further internal parties are offered.
Setting incoming MSNs
The number is used to call your handset/terminal. You can assign several
MSNs.
To confirm the incoming MSN prompt, select [YES].
To confirm the allocation prompt select [YES].
or To move to the next internal number, select [NO].
Press [
Á
] and [OK] to select: (one or more MSNs).
To confirm, press ».
To end the procedure select
Î
.
Allocations for further internal parties are offered.
1.
2.
3.
4.
1.
2.
3.
4.
1.
2.
2.
3.
4.