Operation Manual

16
Grep-eng_2-0.fm
20.10.15
Gigaset Repeater 2.0, IM: A31008-N602-R101-2-SU19
Preparing
Please refer to the user guide of your phone to check whether your base station is suitable for operating
the repeater and how to prepare it for registering the repeater.
Before starting registration, position the Gigaset Repeater directly adjacent to the base station and to a
power connection. If you are already using Gigaset Repeaters, these must be switched on and positioned
close to the base station for this registration procedure.
Automatic registration
Carry out the following steps:
¤ Switch on Gigaset Repeater: Connect the power supply unit to a plug socket. Following this, the device
will enter registration mode for 5 minutes.
¤ Prepare the base station for registering the repeater, in the same way as you would to manually register
a handset. Please refer to the operating instructions for your base station.
The repeater will automatically be registered to the base station. The LEDs will indicate whether
registration was successful or unsuccessful, see page 17 .
De-registration
It may be necessary to de-register the repeater, for example if it has to be replaced. Information about this
can be found in the operating instructions of your base station, or via the system menu of your phone e.g.
C430/C430A, C530/C530A, C620/C630A, E630/E630A. For phones without a repeater system menu, the
repeater can be de-registered using the Reset Repeater procedure, see page 17 .
Installation
Once registration has been carried out successfully, you can install the Gigaset Repeater wherever you
would like to extend the reception range of your handsets. However, you must ensure that there is a power
point at the place of installation and that the left LED remains on constantly after the device has been
switched on.
If the left LED flashes, the Gigaset Repeater is too far away from the base station or reception is being
hindered by thick walls or metal objects for example (e.g. radiators).
When looking for a suitable installation site, a useful guide is a handset which requires a good connection
with the base station at the Gigaset Repeater installation site.
¤ To operate a handset for the first
time in the extended Gigaset
Repeater area, switch off the
handset within the new reception
range of the Gigaset Repeater, but
outside the reception range of the
base station, and then switch it
back on again.
Ensure that no other base stations in registration mode are located close to the Gigaset
Repeater during this procedure.
If you are using more than one Gigaset Repeater in the area of your base station, you must keep
the Gigaset Repeaters at least 10 m apart.
Base station
Extended
reception