Operation Manual

46
Base station settings
A580/A585 / GBR / A31008-M2025-L101-1-7619 / registr_sett.fm / 24.06.2010
Version 4, 29.10.2007
Changing the system PIN
You can change the base station's 4-digit
default system PIN ("0000") to a 4-digit PIN
known only to yourself.
§Menu§ ¢Settings ¢Base ¢System PIN
~ Enter the old system PIN and
press
§OK§. For security, the PIN is
shown as four stars (
****
).
~ Enter your new system PIN and
press
§OK§.
a Press and hold (idle status).
Resetting the system PIN
If you have forgotten the system PIN, you
can reset it to the original code 0000 by
resetting the base station to its default set-
tings. This will also reset every other set-
ting, see "Restoring the base station to the
factory settings"
¢ page 46.
Changing ringer tones
u Volume:
You can choose between five volumes
and the "crescendo" ring,
¢ page 44.
Select "0" to deactivate the base station
ringer.
u Ringer tones:
You can set a ringer melody for external
calls,
¢ page 44.
§Menu§ ¢Settings ¢Base ¢Audio
Settings
¢ Ringer Volume / Ringer
Melody
For how to adjust the settings,
¢ page 44.
Repeater support
With a repeater you can increase the range
and reception strength of your base station.
You will need to activate repeater mode. This
will terminate any calls that are in progress at
the time.
Precondition: A repeater is registered. The
Eco Mode / Eco Mode+ mode is deacti-
vated.
§Menu§ ¢ Settings ¢ Base
¢ Additional Features ¢ Repeater
Mode
§Yes§ Press the display key.
When repeater mode is active, the menu
item is marked with .
Restoring the base station to
the factory settings
When restoring factory settings:
u Handsets are de-registered
– When resetting via the menu:
all Gigaset handsets
– When resetting using the key on the
base station: also all handsets of
other GAP capable devices
u Individual settings are reset
u All lists are deleted
u The system PIN is reset to the original
code 0000
u Eco Mode+ is deactivated
Only the date and time are retained.
Resetting the base station via the
menu
§Menu§ ¢ Settings ¢ Base ¢ Base Reset
§OK§ Press the display key to confirm.
Resetting the base station using a
key on the base station
¤ Disconnect the power cord from the base
station.
¤ Hold down the registration/paging key
(
¢ page 2) on the base station while
reconnecting the power cable to the base
station. Press and hold the key until you
hear a confirmation tone.
The base station has now been reset.
Please note
Repeater support and Eco Mode / Eco
Mode+ (
¢ page 40) cancel each other
out, i.e. both functions cannot be used at
the same time.
‰