User guide

10
A680 (A380-L2) / PHL-TWN eng / A31008-M2005-Z401-1-7619 / main.fm / 14.05.2010
Setting the alarm clock
Activating/deactivating the alarm clock
MENU ¢ Alarm Clock ¢ OK ¢ Activation
¢ OK (‰ = on)
or:
press the alarm clock key g
When activated:
¢ Set the wake-up time ¢ OK
When the alarm clock rings, press any key to switch it
off for 24
hours. If the alarm clock is set, the wake-up
icon
l will appear on the screen and the wake-up
time will be displayed instead of the date.
Setting the wake-up time
MENU ¢ Alarm Clock ¢ OK ¢ Wake-up time
¢ OK
Enter the wake-up time in hours and minutes, then
press
OK.
Phone settings
For details on how to make audio settings, see Menu
tree
¢ page 13.
For details on how to set the system PIN on the base
station, see the Menu tree
¢ page 13.
Resetting the handset
You can reset individual settings and changes that
you have made. Entries in the directory, the calls list
and the handset's registration to the base station will
be retained.
MENU ¢ Settings ¢ OK ¢ Handset ¢ OK
¢ Reset Handset ¢ OK
Cancel the reset with a.
Restoring the base station to the
factory settings
When restoring factory settings:
◆ All handsets are de-registered
◆ Individual settings are reset
◆ All lists are deleted
◆ The system PIN is reset to the original code 0000
Only the date and time are retained.
Software reset
MENU ¢ Settings ¢ OK ¢ Base ¢ OK
¢ Base Reset ¢ OK
Hardware reset
Disconnect the power cord from the base station.
Hold down the registration/paging key
(¢ page 1)
on the base station while reconnecting the power
cable to the base station. Release the key after
approximately 5 seconds.
Operating the base station on
the
PABX
The following settings are only necessary when your
PABX requires them, see the user guide for your PABX.
When entering the digits, enter them slowly one after
the other.
Changing the dialling mode
MENU ¢ I I O 1 1 ¢ The number for the set dial-
ling mode flashes: 0 = touch tone dialling (DTMF); 1 = dial
pulsing (DP) ¢ enter number ¢OK.
Setting recall
MENU ¢ I I O 1 2 ¢ The number for the current
recall flashes
: 0 = 80 ms; 1 = 100 ms; 2 = 120 ms;
3 = 400 ms; 4 = 250 ms; 5 = 300 ms; 6 = 600 ms;
7 = 800 ms ¢ enter number ¢ OK.
Changing pause after line seizure
You can set the length of the pause inserted between
pressing the talk key
c and sending the phone
number.
MENU ¢ I I O 1 O ¢ The number for the current
pause length flashes: 1 = 1 sec.; 2 = 3 sec.; 3 = 7 sec.
¢ enter number ¢ OK.
Changing the pause after the recall key
MENU ¢ I I O 1 4 ¢ The number for the current
pause length flashes: 1 = 800 ms; 2 = 1600 ms; 3 = 3200
ms ¢ enter number ¢ OK.