Operation Manual

101
Appendix
Gigaset 4015 Comfort, IM, A31008-G4015-J102-1-
ANHA.FM
16.5.02
External telephone
numbers can not be di-
alled
Number barring (mail-
box service) is activated
Deactivate number bar-
ring
Telephone number
matches a call barring
number
Compare call barring
numbers
Units/call charges are
not displayed
Tariff information is
missing
Request call charge
pulse transmission
from the telephone
company
You cannot hear The key
F
was
pressed – the micro-
phone is “muted”
Press Î, to activate
the microphone
The incoming call
number is not displayed
although CLIP is set.
The telephone number
transmission is blocked
The callers must permit
the transmission of
their telephone num-
bers at their network
provider
The ringer/dialling tone
cannot be heard.
You have changed the
telephone cord on your
Gigaset.
Ensure, when purchas-
ing a new cord, that it
has the correct pin as-
signment (3-4 assign-
ment of the telephone
leads/EURO CTR37).
Error beep is generated
(descending tone se-
quence)
Wrong input Repeat the procedure;
note the display and, if
necessary, refer to the
operating instructions
The answering machine
announces “PIN is in-
correct” during remote
operation
The system PIN en-
tered is incorrect or set
to 0000
Re-enter the system
PIN or set a PIN other
than 0000
The answering machine
does not record any
messages, announce-
ments or infotexts
Memory is full Delete old messages
Play back and delete
new messages
An answering machine
message does not have
a time stamp
Date/time not set Set date/time
Question Possible cause Possible solution