Operation Manual

101
Customer Service & Assistance
Gigaset DL500A analog / IM-NORD EN / A31008-N3103-R201-2-7619 / appendix.fm / 20.01.11
Version 4, 16.09.2005
Checking service information
If you contact Customer Services, you may
need the base's service information.
Prerequisite:
You must pick up the receiver when in idle
mode or be conducting an external call.
§Options§ ¢Service Info
Confirm selection with
§OK§.
You can select the following information/
functions with q:
1: Base serial number (RFPI)
2: Not in use: - - -
3: Informs the service employees
of the base settings (in hex dia-
gram format) e.g., the number
of registered handsets, repeater
mode.
4: Variant (digits 1 to 4),
Telephone firmware version
(digits 5 to 6).
5: Not relevant
6: Device number of the base. This
contains additional information
for the service employee.
Authorisation
This device is intended for analogue phone
lines in your network.
Country-specific requirements have been
taken into consideration.
We, Gigaset Communications GmbH,
declare that this device meets the essential
requirements and other relevant regulations
laid down in Directive 1999/5/EC.
A copy of the 1999/5/EC Declaration of Con-
formity is available at this Internet address:
www.gigaset.com/docs
Exclusion of liability
Some displays may contain pixels (pic-
ture elements), which remain activated
or deactivated. As a pixel is made up of
three sub-pixels (red, green, blue), it is
possible that pixel colours may vary.
This is completely normal and does not
indicate a fault.
Please note
You may need to wait a few seconds before
§Options§ appears on the display