Operation Manual

105
Appendix
Gigaset DL500A analog / IM-NORD EN / A31008-N3103-R201-2-7619 / appendix.fm / 20.01.11
Version 4, 16.09.2005
u Reading service information, e.g.,
firmware version, serial number, manu-
facturer, MAC address of the base.
u Synchronising the directory on your base
with your PC's Outlook contacts.
u Transferring images as screensavers/
caller pictures from the PC to the resource
directory on the base.
u Downloading sounds (ringer melodies)
from the PC to the base.
You can also use AT commands to:
u Make outgoing calls and accept incom-
ing calls. The display on the base behaves
as if the call was being handled directly
on it.
Data transfer
During the transfer of data between the
base and PC, the message Data transfer in
progress is shown on the display.
Any incoming calls are ignored during this
time. You can use the red end key T to
cancel the data transfer. You cannot enter
anything else via the keypad while data
transfer is in progress.
Using Open Source software
contained in the product
The firmware for your Gigaset phone
includes integrated Open Source licensed
software from third-party providers. These
integrated Open Source software files are
protected by copyright. Rights of use for this
Open Source software that extend beyond
the pure scope of the program execution
intended by Gigaset Communications
GmbH are stipulated in the license condi-
tions for the Open Source software.
If these rights of use are observed, then the
Open Source software can be used as the
license intended. Conflicts may arise
between the license conditions of Gigaset
Communications GmbH and the Open
Source software license conditions. In such
cases, the Open Source software license con-
ditions have priority for the relevant Open
Source parts of the software. You will find
the licence text in its original English version
on the pages that follow. The license condi-
tions are also available at the following web-
site: http://www.gigaset.com/opensource/
If the programs contained in this product are
licensed as part of the GNU General Public
License (GPL), GNU Lesser General Public
License (LGPL) or another Open Source soft-
ware license that requires the disclosure of
the source code, and the product does not
contain software in source code format, then
the source code and copyright information
relating to this software can be downloaded
from the following Internet site:
http://www.gigaset.com/opensource/
The corresponding source code can be
requested from Gigaset Communications
GmbH, but this will incur a EUR 10 process-
ing charge for the provision. This request can
be made within three years from the date of
purchase. Please enclose a receipt with the
date of purchase, the ID number (MAC ID) for
the product and the version number for the
device firmware installed and send to the
following address:
Warranty for other uses of the Open
Source software
Gigaset Communications GmbH does not
provide any warranty for Open Source soft-
ware contained in this product, should it be
used for purposes other than those
intended by Gigaset Communications
GmbH for the execution of the program. The
licenses listed below define the warranty
insofar as intended by the authors and licen-
sors for the Open Source software. Gigaset
Communications GmbH shall not accept lia-
bility for damage occurring through
changes to an Open Source software pro-
gram or product configuration. Further-
more, Gigaset Communications GmbH shall
not accept liability in the event of copyright
Small Parts Dispatch Com Bocholt
E-mail: [e-mail]
Fax: [phone]