Operation Manual

14
First steps
Gigaset DL500A analog / IM-NORD EN / A31008-N3103-R201-2-7619 / starting.fm / 20.01.11
Version 4, 16.09.2005
3. Connecting the base to the mains power supply
1. Insert the small jack on the power cable from the rear into the recess in
the housing.
2 Plug the jack into the port marked with the \ icon on the underside of
the base.
3 Then connect the power cable to the mains power supply.
The software of the base is loaded. After a short while the idle display appears on
the base; it is in idle status (for an example of the display in idle status
¢ page 4).
You can now use your base to make calls and can be reached on your
fixed line
number!
An answering machine on the base is set with a pre-recorded announcement in
answer and record mode (
¢ page 62).
1
3
2
Warning
u Keep the power adapter plugged in at all times for operation, as the base
does not work without a mains connection.
u Use only the power and telephone cables supplied. Pin connections on tel-
ephone cables can vary (pin connections
¢ page 103).