Operation Manual

7
First steps
Gigaset E360 / SEA / A31008-M1805-Y701-1-7619 / starting.fm / 17.03.2010
Version 4, 16.09.2005
For questions and problems see page 23.
Initial charging and discharging of
batteries
Battery charging is indicated in the top right
of the display by a flashing battery icon e,
V or U. During handset operation, the
battery icon indicates the charge status of
the batteries (page 1).
The correct charge status can only be dis-
played when the batteries are first fully
charged
and discharged through use.
¤ To do this, leave the handset in the base
without interruption until the battery
icon stops flashing in the display (approx.
13h).
¤ Once the batteries are fully charged,
remove the handset from the base and
do not put it back again until the batter-
ies are fully discharged.
Please remember:
u Always repeat the charging and discharg-
ing procedure if you remove the batteries
from the handset and re-insert them.
u The batteries may warm up as they are
charging. This is not dangerous.
u After a time the charge capacity of the
batteries will decrease for technical rea-
sons.
Setting the date and time
§Menu§ ¢ Settings ¢ §OK§ ¢ Date/Time
¢ §OK§
~ Enter the day, month and year
with 6 digits and press
§OK§.
Use q to move between
the fields.
~ Enter hours and minutes with 4
digits (e.g. 0 7 1 5 for 07.15 hrs)
and press
§OK§. Use q to move
between the fields.
Once the phone is registered and the time set,
the idle display looks as shown on page 1.
Your phone is now ready for use.
Note:
After the first battery charge and discharge you
may replace your handset in its base after every
call.
Note:
You will find explanations for the symbols and
typographical conventions used in this user
guide in the appendix, page 23.