User guide

54
Connecting the base to the PABX
Gigaset S790 / BRD-SEN EN / A31003-G2100-U112-3-7419 / pabx.fm / 06.07.2011
Version 4, 16.09.2005
Connecting the base to
the PABX
The following settings are only necessary if
your PABX requires them; see the PABX user
guide.
Dialling modes and recall
The current setting is indicated by Ø.
Changing the dialling mode
The following dialling modes can be
selected:
u Tone dialling (DTMF)
u Pulse dialling (PD)
v ¢
Ï
¢ Te lep hony ¢Dialling Mode
s Select dialling mode and press
§Select§ (Ø = selected).
Setting recall
Your phone is preset at the factory for oper-
ation on the main connection. For operation
on a PABX, you may have to change this
value. Please refer to the user guide for your
PAB X.
v
¢
Ï
¢ Te lep hony ¢Recall
s Select recall and press §Select§
(Ø = set value).
Possible values are:
80 ms, 100 ms, 120 ms, 180 ms,
250 ms, 300 ms, 400 ms, 600 ms,
800 ms.
Saving an access code
(outside line code)
Prerequisite: You may have to enter an
access code in front of the number for exter-
nal calls in your PABX, e.g., "0".
v
¢
Ï
¢ Telephony ¢ Access Code
~ Enter or change access code,
max. 3 digits.
§Save§ Press the display key.
If an access code has been saved:
u The access code is prefixed automatically
when you dial a number from the , call
lists or .
u The access code must be entered when
dialling manually and when manually
entering directory, emergency/quick dial
numbers .
u An existing access code is deleted
using Ñ.
•
•