User guide

First steps

Gigaset S790 / BRD-SEN EN / A31003-G2100-U112-3-7419 / starting.fm / 06.07.2011

Version 4, 16.09.2005

DeutschEnglish

Setting up the base and charger (if included)

The base and charger are designed for use in dry rooms in a temperature range of

+5°C to +45°C.

¤ Set up the base at a central point in the building on a level, non-slip surface or

mount the base or charger on the wall (

¢ page 64).

The phone's feet do not usually leave any marks on surfaces. However, due to the

multitude of different varnishes and polishes used on today's furnishings, the

occurrence of marks on the surfaces cannot be completely ruled out.

Please note:

u Never expose the telephone to the influence of heat sources, direct sunlight or

other electrical devices.

u Protect your Gigaset from moisture, dust, corrosive liquids and fumes.

Connecting the base

¤ First connect the tel-

ephone jack 2 and

insert the cables into

the cable ducts.

¤ Then connect the

power adapter 1.

Please note:

u The power adapter

must always be connected, as the phone will not operate without a mains con-

nection.

u Use only the power adapter and phone cord supplied. Pin connections on tele-

phone cables can vary (pin connections

¢ page 59).

Please note

Pay attention to the range of the base.

This is up to 300 m in unobstructed outdoor areas and up to 50 m inside build-

ings. The range is reduced when Eco Mode (

¢ page 37) is activated.