Extra Information

26
Description of new and updated functions
Amendment to "Updating VoIP provider settings"
Gigaset IP Phones / IM-BELG EN / A31008-xxxx-xxxx-x-xxxx / description.fm / 3/23/09
Version 4, 29.10.2007
Amendment to "Updating VoIP provider settings"
The "Profile update reminder" described here only applies to devices for which a firmware version
more recent than 02.140 was already loaded when the device was bought (manufactured after
May 2009).
After the first download of the VoIP provider settings, your phone will check daily whether
a newer version of these settings is available on the Internet. If this is the case, the message
New profile available is displayed when the handset is in idle status and the message key f
flashes.
If you do not want to perform an update at this time, press the message key f and
respond to the subsequent prompt with
§No§. The handset switches to idle status. Your
phone will then remind you at a later date about the new profile (New profile available will
be displayed again).
Amendment to "Defining dialling plans"
This section amends the section "Web configurator – Defining dialling plans – Cost control" in the user
guide for your Gigaset VoIP phone.
When defining dialling plans, the additional option Use Area Codes is now available
(
£ user guide for your phone, Web configurator page Settings ¢ Telephony
¢ Dialling Plans).
Activate the option Use Area Codes for all VoIP calls, if the automatic area code is to precede
all phone number(s) for which the the dialling plan is defined.
You can define the automatic area code on the Web page Settings
¢ Telephony
¢ Dialling Plans under Area Codes.
Correction to "Checking the base MAC address"
This section replaces the section "Base settings – Automatic firmware update" in the user guide for
your Gigaset VoIP phone.
To display the base MAC address, press the following keys in sequence while the handset
is in idle status.
On the Gigaset S67H or S68H handset:
vN5OM5
On the Gigaset C47H handset:
v55OM5
¤ Press and hold the end call key a to return to idle status.
Please note
In the case of dialling plans for emergency numbers, you should always deactivate the
option Use Area Codes.