Specifications

98
Creating/managing access profiles
Gigaset SL75 WLAN / en / A31008-M700-B112-1-7619 / web_server.fm / 24.4.06
Version05.08.2005
¤ Open the IP Routing Web page
(page 96).
¤ If relevant, enter IP addresses in the
Route 1, Mask 1, Gateway 1, Route 2,
Mask 2 and Gateway 2 fields.
¤ Click on Apply.
Making/editing WLAN settings
¤ Open the WLAN Web page (page 96).
¤ Search for available SSIDs and select
available SSID (page 92) or enter name
in the Network Name (SSID) field.
You can also make the following WLAN
settings.
¤ Open the Channel list and select chan-
nel. Which channels are offered
depends on the configured regulatory
domain (page 85).
¤ Open the Output Power (in %) list and
select the transmission power.
¤ Open the Transfer Mode list and select
Mixed Mode or only 802.11b. If IEEE
802.11g is set as a fixed value at the
access point or WLAN router for the
transfer mode, you must set Mixed Mode
here.
¤ Open the Transmission Rate list and
select Auto or a fixed value. The trans-
mission rate is measured in data units
per unit of time (Mbit/s). The Transmis-
sion Rate depends on the selected
Transfer Mode. The possible transmis-
sion rates for the set Transfer Mode are
shown in the list.
¤ In the Fragmentation Threshold field,
specify the size at which voice packets
are to be fragmented.
¤ In the RTS/CTS Threshold field, specify
the minimum packet size (in bytes), for
which an RTS (Request To Send) should
be sent.
¤ If, to improve the signal strength, your
WLAN includes several access points
with the same SSID, specify the mini-
mum value for the access point signal
strength in the Roaming Threshold field.
If the value is undershot, the handset
searches for an access point with a bet-
ter connection quality and establishes a
connection to this access point.
¤ For Preamble Type, click on the Long /
Short option. Note that the IEEE 802.11
standards demand preamble type Long.
¤ Click on Apply.
Setting up encryption and
authentication in the WLAN
¤ Open the WLAN Security Web page
(page 96).
Setting up an access profile without
encryption and authentication
¤ Check that None is selected in both lists
(default setting).
¤ Click on Apply.
Setting up encryption with WEP, WPA or
WPA PSK
¤ Set up encryption (page 93).
¤ If relevant, set up authentication with
802.1x (page 93).
¤ Click on Apply.
Notes:
– Only change the default settings if you
know that this is necessary.
– For more information on the following
parameters, see the Online Help for the
Web configurator.
Note:
The handset must use the same channel as the
access point, as otherwise it cannot establish
radio contact.