Operation Manual

en
35
Fault Possible cause Remedial action
Displays do not
illuminate.
Power failure; the fuse
has been switched off;
the mains plug
has not been inserted
properly.
Connect mains plug. Check whether
the power is on, check the fuses.
Warning signal
sounds.
Temperature display
flashes. Fig. 2/2
Fault – the freezer
compartment is too
warm!
To switch off the warning signal,
press the temperature selection
button 4.
Frozen food is at risk! Note
Frozen food which has started
thawing or which has thawed can be
refrozen if meat and fish were above
+3 °C for not more than one day
or other frozen food for not more
than three days.
If taste, odour and appearance have
not changed, the food can be boiled
or fried and then refrozen.
No longer store the frozen produce
for the max. storage period.
Appliance is open. Close the appliance.
Ventilation openings
have been covered.
Ensure that there is adequate
ventilation.
Too much food was
placed in the freezer
compartment at once.
Do not exceed max. freezing
capacity.
When the fault has been rectified,
the temperature display stops
flashing.
Appliance is not
cooling, temperature
display and light
are lit.
Showroom mode is
switched on.
Hold down temperature selection
button fig. 2/4 for 10 seconds until
an acknowledgement signal sounds.
After a short time check whether
your appliance is cooling.