Specifications

GEMINI
2
Traffic Outstation Handbook
667/HB/32600/000 Page 148 Issue 11
Step
Section
Action to be Performed
10)
9.6.4
If MOVA is to use a Bus / MOVA (Digital) I/O Board, check that the
SOP handset command shows the correct type of I/O boards have
been detected, see page 249.
If MOVA is to use the enhanced serial link to an ST800/700 but the
OMCU has not been configured, enable the facility manually using
‘MIO=2’ and check that the enhanced serial link is active, i.e.
‘EEL:3’.
11)
9.6.5
Enter the correct MOVA licence codes, e.g. ‘LIN=1234 5678 and
LIF=123ABC’.
12)
9.6.6
Set the time and date in the MOVA unit.
13)
9.6.7
Download the site data into the MOVA unit from the PC and then
clear the MOVA working data as instructed on the screen.
14)
9.6.8
Use the commissioning screen to check for following.
a) MOVA is currently not enabled (MOVA enabled = 0)
b) The Controller is ready* (CRB = 1)
c) The Confirm bits are all set to ‘1’, except for the current stage
which should be set to ‘0’.
Watch the controller perform at least one complete cycle to check
that each stage and phase confirm bit is being activated correctly by
the controller.
* It may be necessary to press the ‘Normal’ button on the controller’s
manual panel before it will activate the ‘Controller Ready Bit’.
15)
9.6.8
Also use the commissioning screen to check the operation of each
detector is correct.
The detector display normally shows ‘0’, turning to a ‘1’ when a
vehicle passes over the loop (or the controller has latched a
pedestrian demand).
Also check that vehicles in adjacent lanes do not activate the loop.
16)
9.6.8
Important: The following causes the MOVA unit to take control of
the Intersection and care should be taken to avoid undue disruption
to traffic flows.
Still using the commissioning screen, force each stage in turn and
check that the controller moves to the required stage and that the
correct stage / phase confirm bits are activated.
17)
9.6.9
Check that the Error Log contains no unexpected entries and then
clear the error log.