Technical data

Flowchart for completing the
DX 0 screen forms.
You will find an example to fill in on the next page.
You want to change parameters in form 1?
NO
YES
Repeat the following procedure until you have made all the required
changes in the screen form:
Position the cursor before the parameter field. The display field
F3 at the bottom edge of the screen indicates whether you can
select between alternatives (SELECT displayed) or whether you
can change the parameter value (INPUT displayed).
You want to change parameters in form 2?
NO YES
Press F6 (CONTINUE); the 2nd screen is displayed.
Change the parameters as described above for the 1st
screen form.
Press the enter key; the PG software enters all the parameter settings
from both screen forms and generates data block DX 0.
DX0isstoredinthePG.YoucanloaditintotheCPUusingthe
programmer or you can store it on an EPROM submodule.
- Select input field:
- SELECT:
Press F3 until the required alternative is displayed.
- INPUT:
Press F3 once, the cursor jumps to the beginning
of the field. You can overwrite the field with a
permissible numerical range.
7
Examples of Parameter Assignment
CPU 928B Programming Guide
C79000-B8576-C898-01
7 - 17